Technical Specifications
Key Features
- Smooth transition
- Low flow loss
- Compact design
- Easy installation
- Concentric and eccentric types
- High strength
Applications
- Pump connections
- Pipe size transitions
- Equipment connections
- Boiler feed lines
- Compressor systems
- Tank lines
Dimension Table
| Size | Large Outside Dia. (mm) | Small Outside Dia. (mm) | Thickness (mm) | Length (mm) |
|---|---|---|---|---|
| 1" x 1/2" | 33.4 | 21.3 | 3.38 | 51 |
| 2" x 1" | 60.3 | 33.4 | 3.91 | 76 |
| 4" x 2" | 114.3 | 60.3 | 6.02 | 102 |
| 6" x 4" | 168.3 | 114.3 | 7.11 | 140 |
| 8" x 6" | 219.1 | 168.3 | 8.18 | 152 |
| 10" x 8" | 273.1 | 219.1 | 9.27 | 178 |
Technical Notes
- 01Concentric reducers can be used in vertical or horizontal runs.
- 02Eccentric reducers prevent air locking in suction lines.
- 03Reduction ratio should not exceed 2:1.
Pipe reducer: concentric or eccentric?
A reducer joins two pipe sizes in a straight run. In a concentric reducer both ends share one centreline, which suits vertical lines and pump discharges; in an eccentric reducer one side is flat, so either the top or the bottom of the pipe stays at one level. ASME B16.9 gives the overall length for each size combination, and EN 10253 covers the metric equivalents.
The orientation of an eccentric reducer matters. On pump suction lines it is normally installed flat side up, so that no air or vapour pocket can form ahead of the impeller; in pipe racks and drainable lines it is often installed flat side down to keep a continuous bottom of pipe. The material follows the line class — A234 WPB, A420 WPL6, A403 WP304L/WP316L or A234 WP11/WP22 — and each end is bevelled to the wall thickness of its own pipe.
Specify the large and small sizes (for example 6 × 4), both schedules if they differ, the type and the material. If the step is larger than the standard combinations allow, two reducers in series or a fabricated cone may be needed. Concentric, eccentric and special reducers are described in more detail on the pages of the reducer family.
Related products
What are pipe fittings?
Pipe fittings are the components that change direction, branch, reduce or terminate a pipeline: elbows (90°/45°), tees, reducers, caps and crosses.
Pipe Fittings: guide and FAQRelated Blog Posts
Technical articles, guides and industry analyses

A105 vs A350 LF2: Which Flange Material for Low Temperatures?
A105 and A350 LF2 are two forged carbon steels of the same strength; the real difference is impact testing. LF2 Class 1 is guaranteed by a notch impact test at −46 °C, while A105 has no mandatory impact test. Chemistry and mechanical table, the window that meets both standards, and a flange–pipe–fitting set by design temperature.

Matching Fittings and Flanges to Pipe Schedule: SCH 80, SCH 160, XXS
Schedule is the pipe's wall thickness; fittings and flanges carry the same information in different ways. On butt-weld fittings the schedule follows the pipe, on socket-weld and threaded fittings the class does, and on weld neck flanges the bore does. We put the matching rules for SCH 160 and XXS lines and our calculated weight table in one place.
