Ferro Manganese
Primary manganese source for deoxidation and alloying in steel production.
Technical Specifications
Key Features
- High manganese content (75-80% Mn)
- HC, MC, and LC grade options
- Strong deoxidant property
- Provides hardness and toughness to steel
- Wide grain size range
Applications
- Deoxidation in steel production
- Alloy steel manufacturing
- Hadfield steel production
- Cast iron metallurgy
- Welding electrode manufacturing
Dimension Table
| Element | Min. | Max. | Typical (indicative) |
|---|---|---|---|
| Mn | 75 | 80 | 78 |
| C | 0.50 | 8.0 | 6.5 (HC) / 1.5 (MC) / 0.50 (LC) |
| Si | 0 | 2.0 | 1.0 |
| P | 0 | 0.30 | 0.20 |
| S | 0 | 0.03 | 0.02 |
| Fe | - | - | Balance |
Technical Notes
- 01HC grade used for general steel deoxidation.
- 02MC and LC grades preferred for low carbon steel production.
- 03Fine grains for induction furnaces, coarse grains for arc furnaces.
- 04Keep away from moisture and heat.
Ferromanganese: grade by carbon, size by addition point
Ferromanganese is the standard way to bring manganese into steel, whether for deoxidation, for fixing sulphur as manganese sulphide or for alloying, from the few tenths of a percent in structural steels up to high-manganese austenitic Hadfield steel. Grades are distinguished mainly by carbon. High-carbon FeMn is the cheapest unit of manganese and suits steels where the carbon it brings is acceptable or removed later; medium- and low-carbon grades are used for low-carbon steels, for late additions after decarburisation and in welding consumables.
ISO 5446 and ASTM A99 define the grades and their limits for carbon, silicon, phosphorus and sulphur. Phosphorus deserves attention: it comes in with the ore and is not removed in the ladle, so for clean, low-phosphorus steels the alloy's P content must be checked. The addition is calculated as (target Mn − residual Mn) × steel weight ÷ (Mn content of the alloy × expected recovery). Recovery is higher in a deoxidised bath and in ladle additions than under an oxidising furnace slag.
Size follows the addition point: lumps for the furnace or for the ladle during tapping, crushed grades for ladle trimming and fines for cored wire. For combined Mn–Si deoxidation, silicomanganese is often the more economical route; for silicon alone, use ferrosilicon.
Related products
What are ferroalloys?
Ferroalloys are master alloys of iron with a high share of an alloying element (Si, Mn, Cr, Mo, V...): e.g.
Ferroalloys: guide and FAQRelated Blog Posts
Technical articles, guides and industry analyses

HS Codes for Steel Products: A 6-Digit Guide
The first six digits of any national tariff code are the World Customs Organization's Harmonized System (HS) code, identical in every country. We collected the 6-digit HS headings for steel bars, flanges, fittings, ferroalloys and cast products, plus the thresholds that decide alloy versus non-alloy steel. Final classification is your customs broker's call.

EAF vs BOF: Electric Arc Furnace vs Basic Oxygen Furnace
We compare the electric arc furnace (EAF) and the basic oxygen furnace (BOF) by energy source, charge material, scale, carbon footprint and typical products.
